Written by Chris Smith · Illustrative case study
The situation
A small builder I'd worked with before rang from a job at a property in Hollywell. His skip had been picked up a day late, the next one wasn't coming for three days, and his trades were tripping over roof and floor tiles, mortar, sand and screed and old pavers and retaining blocks.
Why the customer needed help
Their main worry wasn't the cost. It was not knowing what could legally go where, and not wanting to damage the house getting it all out. Both of those are part of the job for us.
What was at the property
By my count there were roof and floor tiles, mortar, sand and screed and old pavers and retaining blocks, along with the usual loose odds and ends that build up around a job like this. It's typical of what we see from owner-builders demolishing structures.
Working in Hollywell
Hollywell is a quiet canal and waterfront suburb near the Broadwater. Hollywell homes often back onto water, so we carry loads carefully past pools, pontoons and landscaped gardens. We protect paving and lawns on the way to the truck and work within bridge and street access limits.
The initial assessment
I arrived at the property and the first thing I noticed was the access. Before I look at the pile, I walk the route it has to travel: doorways, steps, the driveway slope, overhead wires, where the truck can park. For this job I paced it out and worked out we'd need about two-thirds of the tipper.
How the job was planned
I gave them a fixed price there and then, based on volume, and explained what was included: heavy inert material handling, weight-appropriate truck loads and clean fill and rubble separation. They said yes on the spot, so we planned to load in one visit rather than two.
Preparation
We checked the weather, laid out the straps and blankets for anything worth saving, and agreed a hand signal for "stop" because the truck was right on the road.
Step 1
Step one was clearing a working space. We shifted the easy, loose items straight onto the truck so we had room to manoeuvre around the awkward ones.
Step 2
Step two was the stuff in the hard-to-reach spots: the top of the garage racking, under the house, behind the water tank. That's usually where the surprises live, and this job was no different.
Step 3
Step three was the clean-up. Once the last item was out, we swept the floor, raked the ground where needed and walked the customer through the space to make sure nothing they wanted had gone.
Removal, sorting and loading
We loaded by destination rather than by size. Metal on one side for the scrap yard, green waste kept clean, cardboard flattened and bundled, and general rubbish packed into whatever space was left.
From the truck it went to a licensed transfer station, where recyclables were dropped off separately, and anything usable went to a local op shop before the tip run.
Challenges we ran into
Nails and screws were sticking out of most of the timber, and some offcuts had been mixed with good materials the builder still needed.
How we handled them
We knocked over the nails as we went and asked the builder to mark anything he wanted kept with tape. Nothing good went to the tip.
Completion and final result
When the last load was strapped down, the space was empty and swept. The customer walked through with me, signed off, and paid the price we'd agreed at the start, not a dollar more.
What I learned
What stuck with me was how much of it could be reused. People expect building Waste Removal to mean everything goes to landfill. On this job, close to a third of it went somewhere useful.