Written by Chris Smith · Illustrative case study
The situation
An owner-builder at a property in Parkwood was three months into a renovation and the side passage had become a tip. Inspection was due and the certifier needed clear access, but there were broken slab and path pieces, old pavers and stepping stones and brick and block rubble everywhere.
Why the customer needed help
They'd tried doing it themselves the weekend before, got about a quarter of the way through and realised the rest needed a truck, two people and a plan. That's where concrete & Rubble Removal comes in.
What was at the property
By my count there were broken slab and path pieces, old pavers and stepping stones and brick and block rubble, along with the usual loose odds and ends that build up around a job like this. It's typical of what we see from homeowners removing paths and paving.
Working in Parkwood
Parkwood is a settled residential suburb near the university and hospital precinct. Parkwood mixes established homes, units and local businesses, so jobs range from single items to full house and office cleanouts. We plan around driveways, unit car parks and loading zones so the truck is close to the load.
The initial assessment
First look, it was bigger than described, which is normal. People size up their own clutter by memory, not by volume. I measured it roughly by truck-loads, checked for anything we can't take, like paint tins or gas bottles, and found two old cans tucked at the back that we left aside.
How the job was planned
I split the job into zones in my head: what could come straight out the front, what had to come through the house, and what would need two of us and a trolley. That way nobody was waiting on anybody.
Preparation
Before lifting anything, we moved the cars, opened every gate wide and propped the screen door. A clear route is half the job.
Step 1
Step one was triage. We pulled everything into three groups: donate, recycle and dispose. It takes longer at the start, but it means the truck gets loaded in the right order and nothing good goes to landfill.
Step 2
Step two was the stuff in the hard-to-reach spots: the top of the garage racking, under the house, behind the water tank. That's usually where the surprises live, and this job was no different.
Step 3
Step three was the clean-up. Once the last item was out, we swept the floor, raked the ground where needed and walked the customer through the space to make sure nothing they wanted had gone.
Removal, sorting and loading
On the truck, heavy and flat things go on the bottom, long things go along the sides, and anything fragile for donation rides at the front where there's less bounce. Recycling stays in its own section so it can come straight off at the transfer station.
From the truck it went to a licensed transfer station, where recyclables were dropped off separately, and anything usable went to a local op shop before the tip run.
Challenges we ran into
Nails and screws were sticking out of most of the timber, and some offcuts had been mixed with good materials the builder still needed.
How we handled them
We knocked over the nails as we went and asked the builder to mark anything he wanted kept with tape. Nothing good went to the tip.
Completion and final result
When the last load was strapped down, the space was empty and swept. The customer walked through with me, signed off, and paid the price we'd agreed at the start, not a dollar more.
What I learned
It reinforced something I tell every new offsider: ask before you lift. Two minutes of questions at the start saves throwing out the one thing someone really wanted to keep.