Written by Chris Smith · Illustrative case study
The situation
A property manager rang about a rental at a property in Advancetown where the outgoing tenant had left chest freezers, commercial display fridges and wine fridges. The new tenants were moving in the next morning, so whatever we did had to happen that afternoon.
Why the customer needed help
Their main worry wasn't the cost. It was not knowing what could legally go where, and not wanting to damage the house getting it all out. Both of those are part of the job for us.
What was at the property
By my count there were chest freezers, commercial display fridges and wine fridges, along with the usual loose odds and ends that build up around a job like this. It's typical of what we see from households replacing a fridge.
Working in Advancetown
Advancetown is a small rural community near Hinze Dam. Advancetown properties are often larger blocks with sheds, paddocks and lots of trees, so green waste, shed clear-outs and scrap metal are common jobs. Long driveways and gravel tracks are fine; we check gates, slopes and wet ground before backing in.
The initial assessment
I arrived at the property and the first thing I noticed was the access. Before I look at the pile, I walk the route it has to travel: doorways, steps, the driveway slope, overhead wires, where the truck can park. For this job I paced it out and worked out we'd need about two-thirds of the tipper.
How the job was planned
I gave them a fixed price there and then, based on volume, and explained what was included: two-person trolley removal, floor and door frame protection and licensed degassing and metal recycling. They said yes on the spot, so we planned to load in one visit rather than two.
Preparation
We checked the weather, laid out the straps and blankets for anything worth saving, and agreed a hand signal for "stop" because the truck was right on the road.
Step 1
Step one was clearing a working space. We shifted the easy, loose items straight onto the truck so we had room to manoeuvre around the awkward ones.
Step 2
Step two was the stuff in the hard-to-reach spots: the top of the garage racking, under the house, behind the water tank. That's usually where the surprises live, and this job was no different.
Step 3
Step three was the clean-up. Once the last item was out, we swept the floor, raked the ground where needed and walked the customer through the space to make sure nothing they wanted had gone.
Removal, sorting and loading
On the truck, heavy and flat things go on the bottom, long things go along the sides, and anything fragile for donation rides at the front where there's less bounce. Recycling stays in its own section so it can come straight off at the transfer station.
From the truck it went to a licensed transfer station, where recyclables were dropped off separately, and anything usable went to a local op shop before the tip run.
Challenges we ran into
There were still fittings and connections attached, and the floor around it was soft from years of slow leaks.
How we handled them
We disconnected what was safe to disconnect, capped what wasn't ours to touch, and laid boards to spread the weight on the way out.
Completion and final result
When the last load was strapped down, the space was empty and swept. The customer walked through with me, signed off, and paid the price we'd agreed at the start, not a dollar more.
What I learned
What stuck with me was how much of it could be reused. People expect fridge & Freezer Removal to mean everything goes to landfill. On this job, close to a third of it went somewhere useful.