Written by Chris Smith · Illustrative case study
The situation
A retired fella rang me after his son had visited and told him, kindly, that the side of the house had become a hazard. He wanted mixed Waste Removal sorted before his grandkids came up for the school holidays, and there was a mix of metal and wire, green waste and bagged rubbish at a property in Arundel.
Why the customer needed help
Their main worry wasn't the cost. It was not knowing what could legally go where, and not wanting to damage the house getting it all out. Both of those are part of the job for us.
What was at the property
By my count there were metal and wire, green waste and bagged rubbish, along with the usual loose odds and ends that build up around a job like this. It's typical of what we see from trades finishing jobs.
Working in Arundel
Arundel is a leafy family suburb of brick homes and quiet streets. Arundel mixes established homes, units and local businesses, so jobs range from single items to full house and office cleanouts. We plan around driveways, unit car parks and loading zones so the truck is close to the load.
The initial assessment
I arrived at the property and the first thing I noticed was the access. Before I look at the pile, I walk the route it has to travel: doorways, steps, the driveway slope, overhead wires, where the truck can park. For this job I paced it out and worked out we'd need about two-thirds of the tipper.
How the job was planned
I gave them a fixed price there and then, based on volume, and explained what was included: any combination of materials, on-truck separation and correct facility for each stream. They said yes on the spot, so we planned to load in one visit rather than two.
Preparation
We checked the weather, laid out the straps and blankets for anything worth saving, and agreed a hand signal for "stop" because the truck was right on the road.
Step 1
Step one was the bulky stuff. My offsider and I took the largest items out first, tilting them through the door frames rather than forcing them. With metal and wire, green waste and bagged rubbish in the mix, there was no point clearing small things while the big ones were still blocking the way.
Step 2
Step two was the heavy lifting. Anything over about forty kilos went on the trolley or got a two-person lift with straps. No hero stuff. A strained back on the first job of the day ruins the week.
Step 3
Step three was the final check. I went back through every room and corner with the customer, picked up the small stuff the big items had hidden, and swept up.
Removal, sorting and loading
We loaded by destination rather than by size. Metal on one side for the scrap yard, green waste kept clean, cardboard flattened and bundled, and general rubbish packed into whatever space was left.
From the truck it went to a licensed transfer station, where recyclables were dropped off separately, and anything usable went to a local op shop before the tip run.
Challenges we ran into
There was a nest of ants under an old tarp, and a lot of the material was mixed in a way that made sorting slow.
How we handled them
We treated the ants, worked from the outside in, and sorted on the tray as we went rather than on the ground.
Completion and final result
When the last load was strapped down, the space was empty and swept. The customer walked through with me, signed off, and paid the price we'd agreed at the start, not a dollar more.
What I learned
What stuck with me was how much of it could be reused. People expect mixed Waste Removal to mean everything goes to landfill. On this job, close to a third of it went somewhere useful.