Written by Chris Smith · Illustrative case study
The situation
A property manager rang about a rental at a property in Neranwood where the outgoing tenant had left old pool fencing, above-ground pool frames and liners and timber decking and steps. The new tenants were moving in the next morning, so whatever we did had to happen that afternoon.
Why the customer needed help
They'd rung a couple of other outfits and got vague answers about price. I told them I'd come and look, give them a figure on the spot, and they could decide from there.
What was at the property
By my count there were old pool fencing, above-ground pool frames and liners and timber decking and steps, along with the usual loose odds and ends that build up around a job like this. It's typical of what we see from renovating properties.
Working in Neranwood
Neranwood is a small rural area of acreage blocks. Neranwood properties are often larger blocks with sheds, paddocks and lots of trees, so green waste, shed clear-outs and scrap metal are common jobs. Long driveways and gravel tracks are fine; we check gates, slopes and wet ground before backing in.
The initial assessment
I did my usual lap. I check what's heavy, what's sharp, what's reusable and what might be hiding something underneath. A redback in the bottom of a pile isn't unusual on the Coast, so gloves and a torch come out before anyone reaches in.
How the job was planned
The plan was simple: protect the route, clear a path, then work from the far end back towards the truck so we never had to climb over what was left.
Preparation
We put drop sheets down through the hallway and taped corner guards on the door frames. It takes ten minutes and saves arguments about scuff marks.
Step 1
Step one was clearing a working space. We shifted the easy, loose items straight onto the truck so we had room to manoeuvre around the awkward ones.
Step 2
Step two was the loose material. Bags, boxes and odds and ends went into the truck in layers, packed tight into the gaps around the furniture so we weren't carting air to the tip.
Step 3
Step three was the clean-up. Once the last item was out, we swept the floor, raked the ground where needed and walked the customer through the space to make sure nothing they wanted had gone.
Removal, sorting and loading
We loaded by destination rather than by size. Metal on one side for the scrap yard, green waste kept clean, cardboard flattened and bundled, and general rubbish packed into whatever space was left.
From the truck it went to a licensed transfer station, where recyclables were dropped off separately, and anything usable went to a local op shop before the tip run.
Challenges we ran into
The item was heavier than it looked, and it was sitting at the end of a narrow side path with a step down halfway along.
How we handled them
Two of us, a stair-climbing trolley and a sheet of ply over the step. We took it slow and kept it upright the whole way.
Completion and final result
When the last load was strapped down, the space was empty and swept. The customer walked through with me, signed off, and paid the price we'd agreed at the start, not a dollar more.
What I learned
I came away reminded that a fixed price agreed up front takes all the stress out of the day, for them and for us. Nobody's watching the clock or arguing at the end.