Written by Chris Smith · Illustrative case study
The situation
The office manager of a small accounting firm at a property in Bonogin rang on a Wednesday. They'd downsized to a smaller floor and had to hand back the old tenancy by Friday. Left behind were mannequins and display fixtures, signage and light boxes and vinyl and carpet tiles.
Why the customer needed help
Their main worry wasn't the cost. It was not knowing what could legally go where, and not wanting to damage the house getting it all out. Both of those are part of the job for us.
What was at the property
By my count there were mannequins and display fixtures, signage and light boxes and vinyl and carpet tiles, along with the usual loose odds and ends that build up around a job like this. It's typical of what we see from shopfitters clearing a site.
Working in Bonogin
Bonogin is a leafy valley of acreage homes behind Mudgeeraba. Bonogin properties are often larger blocks with sheds, paddocks and lots of trees, so green waste, shed clear-outs and scrap metal are common jobs. Long driveways and gravel tracks are fine; we check gates, slopes and wet ground before backing in.
The initial assessment
I arrived at the property and the first thing I noticed was the access. Before I look at the pile, I walk the route it has to travel: doorways, steps, the driveway slope, overhead wires, where the truck can park. For this job I paced it out and worked out we'd need about two-thirds of the tipper.
How the job was planned
I gave them a fixed price there and then, based on volume, and explained what was included: shelving, counter and display removal, signage and light fitting removal and floor covering lift and cart-away. They said yes on the spot, so we planned to load in one visit rather than two.
Preparation
We checked the weather, laid out the straps and blankets for anything worth saving, and agreed a hand signal for "stop" because the truck was right on the road.
Step 1
Step one was the bulky stuff. My offsider and I took the largest items out first, tilting them through the door frames rather than forcing them. With mannequins and display fixtures, signage and light boxes and vinyl and carpet tiles in the mix, there was no point clearing small things while the big ones were still blocking the way.
Step 2
Step two was the stuff in the hard-to-reach spots: the top of the garage racking, under the house, behind the water tank. That's usually where the surprises live, and this job was no different.
Step 3
Step three was the clean-up. Once the last item was out, we swept the floor, raked the ground where needed and walked the customer through the space to make sure nothing they wanted had gone.
Removal, sorting and loading
We loaded by destination rather than by size. Metal on one side for the scrap yard, green waste kept clean, cardboard flattened and bundled, and general rubbish packed into whatever space was left.
From the truck it went to a licensed transfer station, where recyclables were dropped off separately, and anything usable went to a local op shop before the tip run.
Challenges we ran into
Some of the equipment contained data, so it couldn't just go into general waste, and there were desks bolted to the floor.
How we handled them
The drives were set aside for the client's IT person to remove, and we unbolted the desks with the building manager's okay.
Completion and final result
When the last load was strapped down, the space was empty and swept. The customer walked through with me, signed off, and paid the price we'd agreed at the start, not a dollar more.
What I learned
What stuck with me was how much of it could be reused. People expect retail & Shop Fitout Removal to mean everything goes to landfill. On this job, close to a third of it went somewhere useful.