Written by Chris Smith · Illustrative case study
The situation
The office manager of a small accounting firm at a property in Currumbin Waters rang on a Wednesday. They'd downsized to a smaller floor and had to hand back the old tenancy by Friday. Left behind were gondola and wall shelving, service counters and joinery and mannequins and display fixtures.
Why the customer needed help
Their main worry wasn't the cost. It was not knowing what could legally go where, and not wanting to damage the house getting it all out. Both of those are part of the job for us.
What was at the property
By my count there were gondola and wall shelving, service counters and joinery and mannequins and display fixtures, along with the usual loose odds and ends that build up around a job like this. It's typical of what we see from retailers exiting a lease.
Working in Currumbin Waters
Currumbin Waters is a residential suburb along Currumbin Creek with homes and light industry. Currumbin Waters has a mix of older family homes, units and holiday rentals, which means plenty of furniture swaps, end of lease loads and yard rubbish. Some streets are narrow and busy in holiday periods, so we bring the right size truck and time the job well.
The initial assessment
I arrived at the property and the first thing I noticed was the access. Before I look at the pile, I walk the route it has to travel: doorways, steps, the driveway slope, overhead wires, where the truck can park. For this job I paced it out and worked out we'd need about two-thirds of the tipper.
How the job was planned
I gave them a fixed price there and then, based on volume, and explained what was included: shelving, counter and display removal, signage and light fitting removal and floor covering lift and cart-away. They said yes on the spot, so we planned to load in one visit rather than two.
Preparation
We checked the weather, laid out the straps and blankets for anything worth saving, and agreed a hand signal for "stop" because the truck was right on the road.
Step 1
Step one was triage. We pulled everything into three groups: donate, recycle and dispose. It takes longer at the start, but it means the truck gets loaded in the right order and nothing good goes to landfill.
Step 2
Step two was the loose material. Bags, boxes and odds and ends went into the truck in layers, packed tight into the gaps around the furniture so we weren't carting air to the tip.
Step 3
Step three was loading the donation pile carefully, strapping it separately at the front of the tray so it would arrive at the charity in one piece.
Removal, sorting and loading
On the truck, heavy and flat things go on the bottom, long things go along the sides, and anything fragile for donation rides at the front where there's less bounce. Recycling stays in its own section so it can come straight off at the transfer station.
From the truck it went to a licensed transfer station, where recyclables were dropped off separately, and anything usable went to a local op shop before the tip run.
Challenges we ran into
Some of the equipment contained data, so it couldn't just go into general waste, and there were desks bolted to the floor.
How we handled them
The drives were set aside for the client's IT person to remove, and we unbolted the desks with the building manager's okay.
Completion and final result
When the last load was strapped down, the space was empty and swept. The customer walked through with me, signed off, and paid the price we'd agreed at the start, not a dollar more.
What I learned
What stuck with me was how much of it could be reused. People expect retail & Shop Fitout Removal to mean everything goes to landfill. On this job, close to a third of it went somewhere useful.