Written by Chris Smith · Illustrative case study
The situation
It was just after 7am when the phone went. A man at a property in Kirra had a removalist booked for midday and had just realised the truck wouldn't take small appliance loads, mixed odds and ends and a few bags of rubbish. He needed them gone before the movers arrived.
Why the customer needed help
Their main worry wasn't the cost. It was not knowing what could legally go where, and not wanting to damage the house getting it all out. Both of those are part of the job for us.
What was at the property
By my count there were small appliance loads, mixed odds and ends and a few bags of rubbish, along with the usual loose odds and ends that build up around a job like this. It's typical of what we see from units and townhouses.
Working in Kirra
Kirra is a beachside neighbourhood of units and holiday rentals. Kirra has a mix of older family homes, units and holiday rentals, which means plenty of furniture swaps, end of lease loads and yard rubbish. Some streets are narrow and busy in holiday periods, so we bring the right size truck and time the job well.
The initial assessment
I arrived at the property and the first thing I noticed was the access. Before I look at the pile, I walk the route it has to travel: doorways, steps, the driveway slope, overhead wires, where the truck can park. For this job I paced it out and worked out we'd need about two-thirds of the tipper.
How the job was planned
I gave them a fixed price there and then, based on volume, and explained what was included: pay-per-volume pricing, quick under-an-hour jobs and mixed material accepted. They said yes on the spot, so we planned to load in one visit rather than two.
Preparation
We checked the weather, laid out the straps and blankets for anything worth saving, and agreed a hand signal for "stop" because the truck was right on the road.
Step 1
Step one was clearing a working space. We shifted the easy, loose items straight onto the truck so we had room to manoeuvre around the awkward ones.
Step 2
Step two was the stuff in the hard-to-reach spots: the top of the garage racking, under the house, behind the water tank. That's usually where the surprises live, and this job was no different.
Step 3
Step three was the clean-up. Once the last item was out, we swept the floor, raked the ground where needed and walked the customer through the space to make sure nothing they wanted had gone.
Removal, sorting and loading
We loaded by destination rather than by size. Metal on one side for the scrap yard, green waste kept clean, cardboard flattened and bundled, and general rubbish packed into whatever space was left.
From the truck it went to a licensed transfer station, where recyclables were dropped off separately, and anything usable went to a local op shop before the tip run.
Challenges we ran into
We were fitting the job in between two others, so traffic on the M1 and parking at the property both mattered.
How we handled them
I took the back roads and called ahead when we were ten minutes out, so the customer had the gate open and the car moved.
Completion and final result
When the last load was strapped down, the space was empty and swept. The customer walked through with me, signed off, and paid the price we'd agreed at the start, not a dollar more.
What I learned
What stuck with me was how much of it could be reused. People expect small Load Rubbish Removal to mean everything goes to landfill. On this job, close to a third of it went somewhere useful.