Written by Chris Smith · Illustrative
The situation
I'm Chris Smith from Clear Out. This is an illustrative job, not a real customer account. In this example, I arrive at Sarah's Southport townhouse late on a Thursday afternoon to assess building waste left after courtyard and bathroom work.
Why they needed help
Sarah needs the courtyard cleared so her trades can finish the paving. Loose rubble has narrowed the path beside the house, and the heavier pieces aren't suitable for her household bin. Moving them in a car would mean repeated trips and awkward lifting.
What was at the property
The pile contains brick and block rubble, broken concrete and slab pieces, roof and floor tiles, mortar, sand and screed. Old pavers and retaining blocks sit underneath, with timber offcuts, torn packaging and mixed demolition debris across the top.
The initial assessment
I walk the route before touching the pile, checking the gate width, steps and ground underfoot. Dense rubble can reach the truck's payload limit well before the body looks full. I assess the volume and likely weight, then quote on site before loading.
Planning the job
A ute is parked across the driveway, and Sarah shows me a body corporate rule that loading must finish by 5 pm. With access blocked and little time remaining, I wouldn't start a rushed load. We agree to return within Friday's permitted hours.
Preparation
Sarah arranges for the ute to be moved and confirms the next loading window with the body corporate. I plan the return with our own two-person crew and tipper truck, bringing wheelbarrows, shovels, rubble tubs, a hand trolley, brooms and ground protection.
Step 1
On Friday, we check the driveway is clear and park without blocking neighbouring garages. We lay protective boards along the barrow route and mark out our work area. Gloves, eye protection, safety boots and suitable dust protection go on before handling debris.
Step 2
We remove loose packaging and timber first so we can see the masonry underneath. I check for suspect materials rather than treating everything as ordinary rubble. Clear Out cannot take asbestos, chemicals, liquid paint or gas bottles; any find would need separate arrangements.
Step 3
We separate clean masonry from mixed rubbish, then lift manageable pieces into tubs and barrows. Larger slabs get a two-person lift or the trolley. We don't smash concrete to make it fit, and lightly dampen dusty fines without washing sediment into drains.
The removal
One of us works at the pile while the other moves small barrow loads to the truck. We swap tasks as needed and keep the path clear between trips. Sand, mortar and screed are shovelled up last, once the larger pieces no longer hide sharp edges.
Sorting and loading
We place heavy rubble low in the tipper body, spreading it evenly rather than piling it at the rear. Separate containers keep lighter mixed waste apart. I track the load against payload capacity throughout, leaving a margin instead of filling every available space.
Challenges
The main problem isn't lifting speed. It's getting safe access within the agreed loading hours. The ute has already ruled out Thursday's collection, while the narrow side path means we can't pass each other with full barrows or stage rubble outside neighbours' doors.
How we handled them
We use a single direction of travel at a time and keep tubs inside Sarah's courtyard. Starting early in the approved window leaves time for sweeping and securing the load. If access were blocked again, I'd stop and arrange clearance, not wheel debris around parked cars.
Completion
Once the pile is gone, we sweep the path and courtyard, collect small tile shards and lift our protective boards. I walk the area with Sarah to check the agreed waste has been removed. Before leaving, we secure the separated material and cover the truck load.
The result
In this example, Sarah gets a clear work area within the loading window. Accepted masonry and other recyclables go to licensed facilities; non-recyclable residue goes to landfill. Nothing here is suitable for charity, though reusable goods are directed there on suitable jobs.
Lessons learned
My takeaway is to check access and body corporate conditions before booking collection, especially late in the day. Photos help show the pile, but an on-site check establishes the quote and loading plan. Heavy building waste needs room, weight checks and a workable route.