Written by Chris Smith · Illustrative
The situation
I'm Chris Smith. This illustrative example, not a real customer job, starts straight after lunch on a Thursday in Robina. David needs an old garden shed dismantled, but a pool fence blocks the direct route and his tenant is still partly moved in.
Why they needed help
In this scenario, David wants the shed cleared before the tenant finishes moving. Rusted fixings and sharp sheet edges make it more than a tidy-up. I explain that we need a clear boundary between rubbish and belongings before we undo anything.
What was at the property
I find a small Colorbond steel shed, freestanding shelving, a timber bench and loose paving pieces beside the doorway. The tenant's mower, storage tubs and hand tools are mixed through it. The shed stands on a concrete slab that David wants left intact.
The initial assessment
I check the frame, roof fixings, slab anchors and carrying route. There is no fixed electrical supply in this example. I look for suspect materials too: asbestos, chemicals, liquid paint and gas bottles cannot go on our truck.
Planning the job
I walk David through the scope: empty the agreed contents, dismantle the shed and leave the slab. I quote on site by the truck volume before loading. Our own two-person crew and tipper truck do the work, with no subcontractors brought in.
Preparation
I get David and the tenant to identify what stays, then set those belongings in a separate dry area. We mark out the work zone and lay protective boards along the narrow carrying route. Gloves, eye protection and sturdy boots go on before handling steel.
Step 1
I start with the shelving and bench so we have room inside. We take the shelves apart rather than drag them through the gate. Loose pavers go into manageable tubs, keeping their weight down and clearing the ground around the shed's base.
Step 2
With the shed empty, I remove the door and brace the frame before tackling the roof. We use stable work platforms and cordless drivers, keeping off the thin roofing. One of us supports each sheet while the other releases its fixings.
Step 3
We work through the wall sheets in a controlled order, keeping the remaining frame supported. I remove the frame sections last, then deal with the slab anchors. We do not pull the whole shed over or use the pool fence to steady a panel.
The removal
The side gate is the only suitable way out. I carry long pieces with my crew mate, checking both ends at each turn. We take smaller loads rather than scrape steel along the fence, and keep the tenant away from the route while material is moving.
Sorting and loading
I stack steel flat and low in the tipper, with sharp edges contained and sections restrained. Paving sits low with its weight spread, not piled at the tailgate. Reusable shelving stays separate from demolition waste so it is not crushed or bent.
Challenges
The pool fence leaves too little turning room for full wall panels with framing attached. The partly occupied property also means a box beside the shed is not automatically rubbish. Both issues need decisions before the dismantling gets ahead of us.
How we handled them
I separate the sheets from their framing to make narrower carrying loads, leaving the pool barrier intact and its gate shut. Anything with uncertain ownership stays in the keep area until David and the tenant agree. We do not guess and load it.
Completion
I sweep the slab, collect screws with a magnetic sweeper and check for projecting anchors or sharp fragments. Before leaving, we secure and cover the load. Suitable reusable shelving goes to charity, recyclables to licensed facilities and residual waste to landfill.
The result
In this example, David is left with the original slab cleared of the shed and loose rubbish. The tenant's belongings remain separate and accessible. I walk the route and slab with David, checking that the agreed removal is complete and the pool fence is untouched.
Lessons learned
My main lesson here is to measure the exit before choosing the dismantling sequence. A pool fence is not something to shift for convenience. On a partly occupied property, agreeing what stays matters just as much as knowing which screws to undo first.