Retail & Shop Fitout Removal case study

A Monday Morning Shop Fitout Clear-Out Beside a Broadbeach Resort Pool

Written by Chris Smith · Illustrative

The situation

I'm Chris Smith, owner of Clear Out. This is an illustrative job, not a real customer account. Picture an early Monday start at a small resort retail tenancy in Broadbeach, where Sarah needs an old shop fitout removed before new work begins.

Why they needed help

In this example, Sarah has cleared the saleable stock, but the fittings are too bulky for her to shift. The rear access runs beside a fenced pool courtyard, making it more involved than carrying everything straight out to the truck.

What was at the property

There are gondola and wall shelving units, a service counter, loose joinery, mannequins, display fixtures and disconnected signage and light boxes. Lifted vinyl and carpet tiles sit in piles beside cartons, wrapping and damaged stock.

The initial assessment

I'd walk through with Sarah, checking what stays and what goes. I'd inspect fixing points, sharp edges and the exit route, then quote by truck volume before loading. Anything still wired in would need an electrician to disconnect it first.

Planning the job

For this layout, I'd use our own two-person crew and tipper truck, with no subcontractors. I'd confirm a loading position with site management, measure the narrow turn beside the pool fence and plan which fittings need breaking down inside.

Preparation

Before moving anything, we'd protect the doorway and lay floor protection along the trolley route. I'd bring gloves, eye protection, a drill driver, sockets, pry bar, trolley and straps. We'd keep tools and dismantled parts inside the tenancy.

Step 1

I'd start with loose stock waste and packaging to open up working space. We'd flatten clean cartons, bag small rubbish and set reusable mannequins and displays aside. That gives us somewhere to place shelving without blocking the exit.

Step 2

Next we'd strip shelves from the gondolas, working from the top down before unbolting the frames. One person would support each wall shelving upright while the other removed its fixings. Screws and brackets would go into a tub, not onto the floor.

Step 3

We'd remove the counter drawers, separate screwed joinery sections and check each piece against our access measurements. Disconnected light boxes would come down with two-person support. We'd bundle loose flooring without scraping any unknown adhesive.

The removal

I'd take the awkward counter sections through first, while the route is clear. We'd use the trolley on level ground and lift together at the threshold. The pool fence would stay untouched, with the route kept outside the enclosed pool area.

Sorting and loading

We'd strap the load in stages, protect reusable displays from sharp edges and keep cardboard dry and accessible for unloading.

Challenges

Mid-job, a storm rolls in and rain starts blowing across the access path. The tight corner beside the pool fence becomes harder to negotiate on wet paving. Tall counter panels could catch the wind, so I'd stop those carries rather than force them.

How we handled them

We'd secure and cover the truck load, then work inside while the storm passes. I'd split the remaining joinery into smaller sections. Once conditions were safe, we'd check traction and resume, never propping open a pool gate or removing fence panels.

Completion

After the last carry, we'd sweep up screws, splinters and flooring scraps, then check the access path. I'd walk Sarah through the empty areas against our agreed scope. This would be a cleared tenancy, not a claim that every surface was ready for refitting.

The result

The intended result is room for Sarah's next trades to work. Suitable reusable goods would go to charity, accepted recyclables to licensed facilities and the remaining waste to landfill. We'd keep those streams separate rather than tip everything together.

Lessons learned

My takeaway from this example is to measure the carry route before dismantling starts. A pool fence is a safety barrier, not something to shift for convenience. Leaving room to pause for weather also matters when bulky fittings must travel outdoors.

More case studies

Customer Anecdotes →

Got a job like this?

Call 0444 526 245 for a quote.