Written by Chris Smith · Illustrative
The situation
I’m Chris Smith, owner of Clear Out. This is an illustrative job, not a real customer account. Picture an early Tuesday morning in Robina: Scott opens a shed packed with years of gear. Here’s how I’d approach clearing it with our own two-person crew.
Why they needed help
Scott wants space for garden tools he actually uses. The problem isn’t just the amount of rubbish. Long sheets are wedged behind a mower, wire trails across the floor, and a pool fence blocks the obvious path to the driveway.
What was at the property
Inside, I’d expect rusted tools, a seized bench machine, offcut timber, fencing, steel and roofing sheets. An old mower and garden equipment sit among household overflow. There are also fertiliser bags and containers that need checking before anything moves.
The initial assessment
I’d walk through with Scott, identifying what stays and checking access, sharp edges and unstable stacks. I’d quote on site by the truck volume before loading. Fertiliser and any containers with chemical residue would be excluded, not mixed into the load.
Planning the job
I’d measure the gate opening and turns against the widest items. The pool fence stays intact; nothing goes over it. Our route would use the side gate outside the pool enclosure, provided the mower and sheets could pass without damaging the barrier.
Preparation
I’d park our own tipper truck on a firm, suitable driveway area and set out a trolley, straps, tubs and ground protection. We’d wear gloves, boots and eye protection. Scott would keep children and pets away, with the pool gate shut.
Step 1
I’d start with loose household overflow near the door, opening a working space without disturbing the rear stack. Scott would confirm the keep pile. Sound, usable goods would stay clean and separate for charity, subject to acceptance.
Step 2
Next, I’d inspect the mower for fuel, oil leaks and loose parts before shifting it. Any fuel would need safe handling before collection. We’d strap suitable machinery to the trolley and use two people for the threshold and tight turns.
Step 3
Timber would come out piece by piece, with exposed nails kept away from hands and legs. Loose wire would go into a sturdy tub. Before pulling the rear sheets forward, I’d check behind the stack rather than reach into a blind gap.
The removal
That check reveals the wasp nest in this example. I’d stop work, withdraw from the shed and keep Scott clear. We could only continue elsewhere if it was safely away from the nest. The affected stack would remain untouched pending professional treatment.
Sorting and loading
Once cleared to resume, I’d load heavy machinery low and forward, distributing weight within the truck’s limits. Steel and sheets would lie flat and be restrained. Timber would form a separate section, with reusable goods protected from dirty, sharp material.
Challenges
The fence makes long items awkward to turn, while the nest rules out simply pulling the stack apart. Brittle roofing edges add another risk. I wouldn’t promise a Tuesday finish once pest treatment became necessary, even though same-day work is often possible.
How we handled them
I’d have Scott arrange a qualified pest controller and wait for advice that access was safe. For the sheets, we’d use a controlled two-person carry through the measured route. If anything didn’t fit, we’d reassess rather than dismantle the pool fence.
Completion
After the final carry, I’d sweep up loose debris and check for nails and wire ends. Scott and I would inspect the shed and access path together. Excluded chemicals would remain upright in their original labelled packaging for appropriate disposal.
The result
The intended result is a usable shed with the keep items accessible. I’d secure and cover the load before leaving.
Lessons learned
My takeaway from this example is to check behind stored material before moving it and measure the exit before starting a carry. A shed cleanout needs room to work safely. Neither a full truck nor a tight schedule justifies disturbing a nest.