Written by Chris Smith · Illustrative
The situation
I'm Chris Smith, owner of Clear Out. This is an illustrative job, not a real customer account. In this example, I arrive at Hayley's Southport unit complex late on a Tuesday afternoon to collect tyres from her basement storage cage.
Why they needed help
Hayley needs the cage emptied before handing it back. The building lift is booked for just one hour, and a ute is parked across the driveway. Carrying dirty, bulky tyres through shared areas needs more planning than a quick boot-load to the tip.
What was at the property
The pile contains passenger car tyres, two larger 4WD tyres, a light truck tyre, trailer and caravan tyres, and several tyres still on rims. There are also motorbike tyres and a couple of small wheelbarrow and mower wheels tucked underneath.
The initial assessment
I walk the route with Hayley before touching the pile. I check the cage doorway, lift dimensions and loading limit, then look for loose rims, trapped water and exposed wire. I quote by the truck space required and get her approval before loading.
Planning the job
Our own two-person crew and tipper truck handle the collection, with no subcontractors. I split the work into small trolley loads that fit the lift comfortably. We confirm the lift booking with building management and arrange a clear exit at ground level.
Preparation
We put on gloves and safety boots, inspect the trolley and lay protection along the short indoor route. I keep straps ready for the rimmed wheels. Nothing gets left beside fire doors, and we don't prop open any door that needs to close for fire safety.
Step 1
Inside the cage, we separate loose tyres from wheels with rims. Each tyre gets checked for rubbish and water before it moves indoors. We leave Hayley's unrelated belongings in place and ask her to confirm that every wheel in our pile is going.
Step 2
We load the heavier rimmed wheels low on the trolley, keeping the weight balanced over its base. A strap holds them against the frame. Rather than stack above our sightline, we make extra trips and leave room to steer through the lift doorway.
Step 3
One of us travels with each load while the other receives it at the approved ground-floor collection point. We check the lift's rated capacity against the combined load and operator weight. The trolley stays attended, with no tyres rolling loose.
The removal
Once the driveway is clear, I position the tipper at the agreed loading spot without blocking pedestrian access. We move each batch straight from the trolley to the tray. The larger 4WD and light truck tyres get a two-person lift rather than a strained reach.
Sorting and loading
We lay the rimmed wheels flat and low, spreading their weight across the tray. Loose tyres form stable stacks, with smaller tyres contained so they cannot bounce out. We secure the load with rated restraints; the tipper sides alone aren't enough.
Challenges
The ute is the main holdup because it blocks our truck's approach. Meanwhile, the lift booking is ticking down. Rushing would only turn a short delay into a damaged doorway or a dropped wheel, particularly with the heavier tyres still on rims.
How we handled them
I ask Hayley to contact the ute's driver through building management while we prepare the first loads inside the cage. We only start the lift runs once the exit is usable. If that takes too long, we ask for more lift time rather than overfill it.
Completion
After the last trip, we sweep loose grit from the cage and check the lift and corridor for marks or debris. Hayley walks through the cleared space with me. Before driving away, I inspect the restraints again and collect our floor protection and trolley.
The result
In this example, the ute moves in time and the tyres are out within the booked hour. They go to a licensed facility confirmed to accept those tyre types, including wheels on rims. We don't leave them at a charity or mix them into general landfill rubbish.
Lessons learned
My takeaway is to confirm driveway access as carefully as the lift booking. Photos of the pile help, but an on-site check still matters for weight, rims and awkward corners. For a similar Gold Coast collection, call me at Clear Out on 0444 526 245.