Written by Chris Smith · Illustrative
The situation
I’m Chris Smith, owner of Clear Out. This illustrative example follows a garden waste pickup in Robina, mid-morning on a Tuesday. Jess is a fictional customer, and the job shows how I’d approach this sort of backyard clear-out.
Why they needed help
Jess had pulled out a tired garden bed but couldn’t shift the leftovers. The damp bags were awkward to lift, and loose soil wasn’t something she wanted in her car. She needed the waste removed before spreading fresh mulch.
What was at the property
The pile held old mulch and bark, soil and turf offcuts, terracotta and plastic pots, weed mat, plastic edging, dead plants and root balls. Bagged garden refuse sat beside it, with a few pot shards visible underneath.
The initial assessment
Before moving anything, I’d walk the pile with Jess, check what was staying and inspect access. The side passage was narrow, and its front gate was locked with no key available. I’d also check the soil for rubble and the bags for hidden rubbish.
Planning the job
In this example, the garage had a rear pedestrian door opening onto the passage behind the gate. With Jess’s permission, that gave us a way out. I’d quote by truck volume on site before loading, allowing for the soil’s weight within our payload limit.
Preparation
Once Jess accepted the quote, our own two-person crew would bring tubs, shovels, a broom, gloves and a narrow trolley from our tipper truck. We’d protect the garage floor and move stored items aside to make a clear path through it.
Step 1
I’d start with the pots and loose edging so we could see the ground. Intact pots would go aside for reuse checks. Broken terracotta would go into a rigid tub, not a soft bag where a sharp edge could catch someone’s hand.
Step 2
Next, we’d peel up the weed mat and shake loose soil back onto the pile. Plastic edging and matting would stay separate from plant material. Long strips would be bundled short enough that they couldn’t snag along the passage.
Step 3
We’d loosen the root balls with a shovel and split bulky clumps into manageable loads. Soil, turf, bark and mulch would be scooped into tubs only partly filled. Smaller loads make more sense than wrestling a heavy bin around a tight corner.
The removal
One crew member would work at the pile while the other took loads through the passage and garage. At the rear doorway, we’d lift tubs over the sill together as needed. Nothing would be dragged across the floor or leaned against Jess’s car.
Sorting and loading
At the truck, dense soil and turf would sit low and spread across the tray, with lighter plant waste contained above. Pots suitable for charity would be secured separately. Bagged material would be checked before loading, not treated as green waste on trust.
Challenges
The locked gate ruled out the shortest route. The garage detour added a doorway and a turn, while the narrow passage left little room to pass. Damp mulch and soil also meant a load could become too heavy well before the tray looked full.
How we handled them
I’d leave the gate and lock untouched. We’d run the trolley one way at a time, keep each tub easy to control and check tray weight as loading progressed. If the assessed load exceeded capacity, I’d discuss another trip before taking more.
Completion
After the last tub, we’d shovel up remnants and sweep the passage and garage rather than hose soil into drains. I’d walk Jess through the cleared area, check behind the stored items and secure the truck load before leaving.
The result
In this example, Jess gets the bed cleared without damaging the gate. Reusable pots go to charity if accepted; suitable green waste and recyclables go to licensed facilities. Dirty matting and other non-recoverable rubbish go to landfill.
Lessons learned
My takeaway from this scenario is to check the whole exit route before quoting or lifting. A missing gate key needn’t stop the work if there’s an approved alternative. Separating plastic early also keeps it out of material intended for recovery.