Mixed Waste Removal case study

Illustrative case study: a mixed waste load through a narrow passage in Robina

Written by Chris Smith · Illustrative

The situation

I'm Chris Smith, and this is an illustrative job, not an account of a real customer. In this example, I arrive at Leanne's Robina property late on a Tuesday afternoon to assess mixed waste spread between the garage and backyard.

Why they needed help

Leanne has cleared rooms and tidied the garden, but the piles are too bulky for her car. She needs the garage floor back and the path clear. I can see this needs a planned carry route, rather than dragging everything out at once.

What was at the property

I find a small table, a worn mattress, timber offcuts, loose wire, metal shelving, branches and bagged rubbish. There's also an old washing machine and a computer monitor. The table looks reusable; the mattress is torn and badly marked.

The initial assessment

I walk through with Leanne and confirm each item before estimating its share of our tipper truck. I quote on site by truck volume before loading. I also explain that we cannot take asbestos, chemicals, liquid paint or gas bottles.

Planning the job

I check the side passage, gate opening and turn beside the house against the widest items. The washing machine can leave through the garage. The mattress needs two people through the passage, with nothing stacked along its route.

Preparation

Once Leanne accepts the quote, I position our own truck for safe access and put on gloves and boots. My crew mate and I set out straps, blankets, a broom and a trolley. Clear Out uses its own two-person crews, not subcontractors.

Step 1

I start with loose wire and short offcuts beside the gate so neither can catch our feet. Any protruding nails stay covered during the carry.

Step 2

We carry the mattress on edge, one person at each end, stopping before the tight turn to reset our grip. I protect the corner with a blanket. We take the table separately, keeping its legs away from the wall and door frame.

Step 3

I check that the washing machine is disconnected and its hoses are drained before moving it. The monitor goes into a padded crate, not under scrap. We gather branches into manageable bundles and check bags for leaks or sharp edges.

The removal

With the route clear, I keep loads moving to a staging area beside the truck without blocking the footpath. We use the truck's loading equipment within its rated capacity, rather than trying to lift the washing machine over a side.

Sorting and loading

I place heavy items low and distribute weight across the tray. The appliance stays upright and strapped; timber lies flat with ends contained.

Challenges

Partway through, a trolley wheel breaks while we're moving a light bundle of offcuts. We lower the bundle safely and stop using the trolley. The narrow passage already limits our footing, so pushing on with damaged gear isn't an option.

How we handled them

I put the broken trolley aside for repair and tell Leanne why the pace has changed. We split the remaining offcuts into smaller hand-carried loads. For bulky pieces, we use coordinated two-person carries, pausing wherever our grip needs adjusting.

Completion

I sweep the passage and garage, checking for nails and wire fragments before walking through with Leanne. At the truck, I check straps, close the tailgate and secure the load cover. Nothing loose should escape on the road.

The result

In this example, Leanne gets her garage and path back. I set the table aside for charity, subject to acceptance. Recyclables go to licensed facilities; the unusable mattress and residual rubbish go to landfill. I keep those streams separate.

Lessons learned

My takeaway from this scenario is to check access before choosing equipment, then adjust when conditions change. A broken wheel means stopping and replanning. Late-afternoon light also matters: I'd pause work rather than carry through a dark passage.

More case studies

Customer Anecdotes →

Got a job like this?

Call 0444 526 245 for a quote.