Written by Chris Smith · Illustrative
The situation
I'm Chris Smith from Clear Out. This illustrative case study describes how I'd handle an early Tuesday morning waste removal in Robina. Sarah and the property are made-up examples, not a record of a real customer's job.
Why they needed help
In this example, Sarah has cleared bedrooms and tidied the yard, but the waste is still scattered around. A tight internal staircase makes getting furniture downstairs awkward, and several items are too bulky for her to move safely alone.
What was at the property
The load includes an armchair, cushions, flat-pack shelving, bagged yard waste, timber lengths, plaster offcuts, wire and metal fittings. Flattened cartons, plastic wrapping and bags of general non-hazardous household waste fill the garage corner.
The initial assessment
I'd walk through with Sarah before touching anything, checking what goes and what stays. I'd inspect the stair turn and driveway access, then quote by truck volume on site before loading. Anything of uncertain composition would need checking first.
Planning the job
I'd use our own two-person crew and tipper truck, with no subcontractors. We'd plan the upstairs carry first while the access path is clear, then collect the garage and yard piles. I'd park close without blocking the footpath.
Preparation
We'd lay protective runners over the internal route and pad the stair corner. Gloves, sturdy boots, lifting straps, a trolley and a drill would be ready. Sarah would keep children and pets away from the stairs and loading area.
Step 1
Upstairs, I'd remove loose cushions and check whether the armchair's feet unscrew. We'd measure its narrowest profile against the stair turn before lifting. The shelving would come apart with the drill, with screws collected in a container.
Step 2
We'd carry the chair down together, keeping it under control and stopping before each turn. One person would call the movements. If the angle didn't work, we'd set it down and reassess rather than push it against the wall.
Step 3
I'd place sharp wire ends inside a rigid container and bag loose plaster fragments. We'd check yard bags for hidden fittings before carrying them out to the truck.
The removal
We'd trolley suitable bags along the level driveway and carry long timber with a person at each end where needed. The second crew member would keep the route clear, checking for dropped screws and scraps between trips.
Sorting and loading
I'd put heavier material low and spread the weight across the tray. Timber would lie flat, with sharp ends contained. Metal and clean cardboard would stay grouped for unloading; a reusable chair would be protected from dirty waste and secured.
Challenges
The stair landing leaves little room to reposition the chair. Partway through the garage, Sarah also decides she wants to keep a small side table and some timber offcuts. That changes the agreed pile and potentially the volume going on board.
How we handled them
I'd stop loading while Sarah marks out a separate keep area. We'd move the table and chosen timber there, then confirm the remaining load and any quote adjustment before continuing. On the stairs, we'd use short, coordinated moves, not force.
Completion
After loading, we'd sweep the work areas and walk through with Sarah to check nothing intended to stay had gone. I'd secure and cover the load before leaving. Reusable goods would go to charity, recyclables to licensed facilities and the rest to landfill.
The result
The intended result is a clear staircase, usable garage space and a yard without loose waste piles. Sarah keeps the items she's reconsidered. The example shows why I leave room for a final decision instead of treating every nearby object as rubbish.
Lessons learned
My takeaway is to establish the keep pile early and measure tight access before lifting. I'd also confirm exclusions at assessment: we cannot take asbestos, chemicals, liquid paint or gas bottles. Those need a separate disposal arrangement.